Hardcore Sledder banner
1 - 3 of 3 Posts

·
Registered
Joined
·
861 Posts
you can shim then for two bucks, do a search on here someone had a part no. and thickness for the shim for this, I did the same conversion and wish i didn't spend the money when you can just shim it or cut it back some.
 

·
Registered
Joined
·
951 Posts
You increased your bore by 5mm, divide by 2 for 2.5mm(.098) and add .75mm for clearance for shims that are somewhere around .125-130 thousandths. Personally I run 1mm extra for clearance on my big bore for some safety margin.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top