Hardcore Sledder banner

1 - 6 of 6 Posts

·
Registered
Joined
·
861 Posts
Discussion Starter #1
I am going to be using the Flair Tool on my sled this weekend, but my SnoPro X Country style edge grips may not be in till the end of the month.
Could someone who has these grips on their sled give me a measurement of how far into the board they go. I need to make sure I don't put the Flair holes to close to the edge.

Thank you,

Kevin
 

·
Registered
Joined
·
3,411 Posts
Captainkev,
The snopro grip plates mount 2-5/8" in from the very outer edge of the ribbed/fluted heat exchanger inward. If you measure the size of the running board heat exchanger and subtract it from 2 5/8", that should give you the exact amount of "flat" running board surface you have to work with.

Did I explain this so you can understand?? Hope this info helps....
-John
 

·
Registered
Joined
·
861 Posts
Discussion Starter #4
JLeo,

So basically, If I draw a line 2 3/4 inches in from the outside of the heatexchanger, that should leave enough room to put on the edge grips ?

Kevin
 

·
Registered
Joined
·
861 Posts
Discussion Starter #6
Thanks for the info.


Kevin
 
1 - 6 of 6 Posts
Top