Hardcore Sledder banner

Torx screws for knee pads - Damn things

569 views 5 replies 4 participants last post by  hugh 
Another method that has worked for me is to thread the torx bolt into the brass knurled insert and the heat the insert with a propane torch. Then quickly press the insert back in to the cavity with about an eighth of a turn and let cool a few minutes. The unthread the bolt and install you pads. Don't use a power screwdriver!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top