Hardcore Sledder banner

1 - 2 of 2 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
im looking for a good setup for a standard f7. last week when riding we could not get it to hook up on prime conditions(no studs and will not stud) my zr 500 would take it out of the hole. It cornered great and was not to soft in 6to12 inch bumps, just no weight transfer happening. also we are putting on ultaflex skis same as c&a. i would really appreciate some of your replies, rider weight 200lb. thanks!
 

·
Registered
Joined
·
145 Posts
Front springs,back off until loose, then tighten 1 to 2 turns to keep tension on spring retainers, shock spring in front of rear suspension, same.Make these adjustments with weight off these springs. Set rear coupler blocks on 1, don't run too much preload on rear springs.
 
1 - 2 of 2 Posts
Top