Hardcore Sledder banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
4,444 Posts
Discussion Starter #1
Sled has the Ripsaw 137 x 15 x 1.2 track on it. Any idea if the lug height is actually 1.2" (thought Ripsaws were 1.25")?

I have the OEM tunnel protectors installed, I would like to run the longest stud I can. What is folks experience on how far over the lug a person can run safely in this chassis?

Thx!
 

·
Premium Member
Joined
·
5,721 Posts
Sled has the Ripsaw 137 x 15 x 1.2 track on it. Any idea if the lug height is actually 1.2" (thought Ripsaws were 1.25")?

I have the OEM tunnel protectors installed, I would like to run the longest stud I can. What is folks experience on how far over the lug a person can run safely in this chassis?

Thx!
Most run 1.325s on the 1.25" ripsaws. That gives you about 1/4" of penetration. Some run 1.450s which would give you 3/8". I personally wouldn't go over 3/8. (note those stud lengths (woody's) are not the overall length of the stud)
 

·
Premium Member
Joined
·
5,721 Posts
Here’s my 2015 Renegade 1200. The middle belt is the pre-marked 96. This pattern will give you a total of 144 and puts a similar # of studs in contact with the ground as a 120” with 168 studs (4 per pitch).
 

Attachments

1 - 3 of 3 Posts
Top