Hardcore Sledder banner

1 - 12 of 12 Posts

·
Registered
Joined
·
3,538 Posts
Discussion Starter · #1 ·
is there anyway to take the spindles out of the housing? i am ganna machine down my spindle housings a bit like on the sno pros for some weight lose and a metals project and it will be much easier with out them in the housing.
 

·
Registered
Joined
·
400 Posts
I was just looking at those too, trying to figure out how to get them apart. The part diagram doesn't show them coming apart. I want to get mine powder coated.
 

·
Registered
Joined
·
3,538 Posts
Discussion Starter · #3 ·
i honestly think they are put together and welded. on mine if you take the top cap off and look down it the very top piece looks like it was seperate then tacked together. i hope thats not the case.
 

·
Registered
Joined
·
400 Posts
Originally posted by slow800zr@Sep 19 2005, 09:35 PM
if you want to powder coat clean them good and bake them for a while before you powdre them
<div align="right">index.php?act=findpost&pid=883044
[/quote]

What will baking them prior to powder coating do? Do you mean to bake them before removing original paint (by sand blasting, I'm guessing) or after?
 

·
Registered
Joined
·
226 Posts
baking will make powder coat come off easier and also get all the grease out of there. grease and powder dont mix for some reason :frech32:
 
1 - 12 of 12 Posts
Top