Hardcore Sledder banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,477 Posts
Discussion Starter · #1 ·
Does anyone have a parts schematic for the driven pulley (secondary clutch) on a 02 ZR800

An aluminum ring, about the width of a bearing, departed from the secondary and was tinkling around the shaft between the clutch and the main housing.

The secondary makes a terrible noise when you cycle the clutch while the sled is on the stand. Would this piece be part of a bearing that allows the inside sheave to spread out smoothly ?
 

·
Registered
Joined
·
907 Posts
Here you go. I suspect part #8 is the culprit. Could also be the jackshaft bearings. Only way to know for sure is to take the secondary apart and check for worn parts.
 

·
Registered
Joined
·
1,477 Posts
Discussion Starter · #4 ·
It was part #8...That part is a larger diameter than the shaft...it is hard to say that it really does anything.

This sled is for sale, so I'll replace that part and put it back together...I'll let the next guy worry about anything else that may be worn in there...

Thanks lads...
 
1 - 5 of 5 Posts
Top