Hardcore Sledder banner

1 - 9 of 9 Posts

·
Super Moderator
Joined
·
36,442 Posts
Discussion Starter #1
New or used mounts can be made unbreakable, simple cut off studs, drill or bore the correct size hole through the whole mount per your bolt O.D. size needed, fabricate a steel or bronze bushing with correct inside diameter hole size, press into mount, now use a through bolt and lock nut of your choice.
 

Attachments

·
Registered
Joined
·
8,478 Posts
Very nice. Going to have to give this a try. I'll have to get some bushing stock.
 

·
Banned
Joined
·
17,243 Posts
New or used mounts can be made unbreakable, simple cut off studs, drill or bore the correct size hole through the whole mount per your bolt O.D. size needed, fabricate a steel or bronze bushing with correct inside diameter hole size, press into mount, now use a through bolt and lock nut of your choice.
I always wondered how to make those front mounts better on my 2000 XCR 800.
 

·
Super Moderator
Joined
·
36,442 Posts
Discussion Starter #4
I always wondered how to make those front mounts better on my 2000 XCR 800.

Making bushings now for the "1 piece engine plates" to be used with the 2 part rubber "mushroom" type mounts as used on the Aggressive Chassis and others., factory bushings that come with the rubber mounts are 5/8" O.D. & 7/16" I.D. and need to be 3/8" I.D. for a tight bolt fit.
 
1 - 9 of 9 Posts
Top