Hardcore Sledder banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,030 Posts
Discussion Starter · #1 ·
Hello,

I am wondering if anybody ever has had a bolt break in this. I tried taken it out, but the rails have a lip that the shaft can not get over. Anyway can you think of how too get this whole unit out without taken the sunspension completely out? I am going too try and drill and tap it on the sled, but need too go and get some good drill bits. Was going too just take the shaft over too my father inlaws and use his shop equipment.

What a pisser errrrrrrrrr

[attachment=413421:edge_rear.gif]
 

·
Premium Member
Joined
·
12,019 Posts
I had one break

I had the skid out for a rebuild so It was easy out side the sled.

Rust and red locktight like some heat applied to help get the bolt out.
 

·
Registered
Joined
·
1,030 Posts
Discussion Starter · #3 ·
Well, I took a good look at this morning. I forgot too take the other side bolt out da. I then was able too seperate the rail a little bit enough so that
I could wiggle that shaft out. What a pisser. Oh well. Fun part will be putting all back in . yay.


[attachment=413807:edge_rear.gif]
 
1 - 3 of 3 Posts
Top