Hardcore Sledder banner
1 - 1 of 1 Posts

·
Registered
Joined
·
385 Posts
Discussion Starter · #1 ·
I took off my pipe yesterday and looked at the pistons, I have small little scratches on the side of the piston starting around 1/2 inch below the rings. There is no discolouration,,,,,

I can't figure out how to take a picture of them, the flash keeps reading the engine block.

Is this considered bad?????? or normal wear (F7 efi, 2005, 2500 miles). I did once get a temp warning (blinking light), if I remember the numbers right,,,, the light blinks at 180,, and 195 is burn down??


any comments

Doug
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top