Hardcore Sledder banner
1 - 4 of 4 Posts

·
Registered
Joined
·
145 Posts
Discussion Starter · #2 ·
OK I will answer my own reply GLS wrote me in AMSOW Forum he told me a lot less Idle screw and to turn my air & fuel screws to 1.75 so thought some one with the same problem would like to know .


HAPPY HOLIDAYS TO ALL
 

·
Registered
Joined
·
474 Posts
What problems are yo having? I am having a hard time finding a good idle. It just seems that I am chasing my tail. high/low ect. I try to adjust it after a good run, then I'm chasing. Any ideas? Dan
 

·
Registered
Joined
·
145 Posts
Discussion Starter · #4 ·
GLS said it was way to much adjusting the Idle screw on top he told me to adjust my air/fuel instead
also said no two carbs are alike new that and watch for carb icing on the bell that will not make it ide right
I asume he is saying make sure the carb boots are on right.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top