Hardcore Sledder banner
1 - 3 of 3 Posts

·
Registered
Joined
·
384 Posts
Discussion Starter · #1 ·
I am wondering how you guys that are running the offset axle from Hi perf. Eng. that require the 1" ID bearing, are getting the M-series 8" wheels to fit ? The stock 8" M wheel bearing is smaller than 1" so its not like it just slides right on. Are you changing the bearings or just turing the offset axle down? Thanks.
 

·
Registered
Joined
·
186 Posts
I am wondering how you guys that are running the offset axle from Hi perf. Eng. that require the 1" ID bearing, are getting the M-series 8" wheels to fit ? The stock 8" M wheel bearing is smaller than 1" so its not like it just slides right on. Are you changing the bearings or just turing the offset axle down? Thanks.[/b]

Hatch,

Go to this link, pretty informative if you want to go to 8" rear wheels. Its a blog on Arctic Chat.

Click Here
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top