Hardcore Sledder banner

1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
What size ripsaw can i put on a 2000 srx with a m-10 ? and stud length. Also 3500 miles what should i do as far as mat and so forth for the shocks ? Can i put better skis and shocks? :augen41:
 

·
Registered
Joined
·
106 Posts
Ripsaw comes in inch and a quarter lug only.To stud that setup you will need a 8 tooth driver kit for your track. there is not enough clearance with the 9 tooth drivers.Maximum performance sells a kit to do it including gearing to compensate for the smaller drivers I don't remember how much,but its not cheap.Not sure about your other questions,good luck withit all. :div20:
 
1 - 2 of 2 Posts
Top