Hardcore Sledder banner
1 - 3 of 3 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Does anyone know the torque specs on a '94 Wildcat 700 EFI for the exhaust manifold stud that goes into the head as well as the nut that holds the manifold on? With the block being aluminum I don't want to just guess at it. Thanks. :i_need_snow:
 

·
Doesn't play well with other
Joined
·
5,450 Posts
Does anyone know the torque specs on a '94 Wildcat 700 EFI for the exhaust manifold stud that goes into the head as well as the nut that holds the manifold on? With the block being aluminum I don't want to just guess at it. Thanks. :i_need_snow:[/b]
There not that critical, I would imagine some were around 22-28lbs. I would just use a short 1/4in drive ratchet and snug them up good'n tite
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #3 ·
Thanks for the info Flash and Flare, I just wanted to make sure they're tight enough without going overboard. The big twin has alot of vibration to it. Thanks again. :thumbsup:
 
1 - 3 of 3 Posts
Top