Hardcore Sledder banner
1 - 3 of 3 Posts

·
Registered
Joined
·
219 Posts
Discussion Starter · #1 ·
Has anyone out there installed the bullseye air intakes, if so could you let know, i'm not sure where to start. You would think d&d would give you some directions with the kit. Thanks ****
 

·
Registered
Joined
·
6,976 Posts
I would contact D&D and make them tell you exactly how to put them in. If you are putting them in an EFI I would be VERY careful. Hopefully you don't burn it down with the extra air.
Cat S.
 

·
Registered
Joined
·
219 Posts
Discussion Starter · #3 ·
Called D&D today , they said that the bullseye go in front of the computer box, 2 on each side on the air intake box. I told him it would be nice to have some instructions with these, he said yes i know. He was a big help, he also told me that they will not hurt the EFI motors, i suppose your guess is as good as mine. Im going to hold off installing them until i hear form someone who's done this..... **** :blink: :blink:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top