Hardcore Sledder banner
1 - 6 of 6 Posts

·
Registered
Joined
·
168 Posts
Discussion Starter · #1 ·
I know this stuff has probably been posted on here alot before, but whenever I try to search for it the search tool never works for me, it just ends up going to a blank page that says error.

Anyways I need the following torque specs to put a 1998 ZR 600 motor back together.

Bolts for the bottom of the engine casing -

The nuts at the base of the cylinders -

Head bolts (and the order to tighten them) -

Engine mounts (if there are any specs for it?) -


Thanks in advance, I really appreciate any help you guys can give me for this.
 

·
Registered
Joined
·
73 Posts
Case bolts 6mm ones are 6-8.5 foot pounds, the 8mm ones are 13-20 foot pounds and the 10mm ones are 29-43 foot pounds
Cylinder Base bolts are 29-43 foot pounds
Head bolts are 13-20 foot pounds

straight from my Cat performance manual (2001 edition)

Ronski
 

·
Registered
Joined
·
95 Posts
Just use a 3/4" impact gun and tighten them all in a circular pattern :)

WAIT! I was just kidding :) Please don't.


It looks like you got the info you needed, just though it would be funny to post this.
 
1 - 6 of 6 Posts
Top