Hardcore Sledder banner
1 - 4 of 4 Posts

·
Registered
Joined
·
108 Posts
Discussion Starter · #1 ·
Heading to the Bighorns in a month and looking to gather the parts needed. Riding is at 8000 - 9000 ft. How have you set up your RMK's for this altititude. Temps should be between +5* to +30*.

Jet size
Needle Position
Air Screws
Weights
Primary Spring
Gearing
Secondary Spring
Helix

Thanks for your knowledge!
 

·
Registered
Joined
·
43 Posts
Heading to the Bighorns in a month and looking to gather the parts needed. Riding is at 8000 - 9000 ft. How have you set up your RMK's for this altititude. Temps should be between +5* to +30*.

Jet size
Needle Position
Air Screws
Weights
Primary Spring
Gearing
Secondary Spring
Helix

Thanks for your knowledge![/b]

340-350 for jets. Needle in #2 position. 1 1/2 on air screws. 60 or 62g weights. Almond Round Primary spring. 19/43 gearing with 74P chain. Red/black or black/reb secondary spring. I've personally had good luck with a 64/40/46 helix.
 

·
Registered
Joined
·
2,498 Posts
340-350 for jets. Needle in #2 position. 1 1/2 on air screws. 60 or 62g weights. Almond Round Primary spring. 19/43 gearing with 74P chain. Red/black or black/reb secondary spring. I've personally had good luck with a 64/40/46 helix.[/b]
In addition ,my escape came with pink ev springs and 2.0 cutaways . It was delivered for 9000 ft. from tri-city polaris in centerville utah.
 

·
Registered
Joined
·
6,556 Posts
To add to my pm, you should change the ves springs as mentioned. You should also have the stainless ves valves. Run yellow springs for about 5-8000ft. with the stainless, #7041704-05, and white above 8000ft. #7041704-???? (don't have the - number).
 
1 - 4 of 4 Posts
Top