Hardcore Sledder banner

1 - 8 of 8 Posts

·
Premium Member
Joined
·
9,228 Posts
Discussion Starter #1
Just a heads up Firecat owners. My right front (throttle side) skid mount bolt came loose a few times but I was aware some did that. I took a few minutes to pull the bolt after 300 miles and the SPACER WAS MISSING!!!!! Its the bronze one that slides in the front arm that the bolt goes through. Part # 0104-629 spacer front arm. It was missing from the factory. Grease comng out on the tunnel is a giveaway that you have a problem.
 

·
Registered
Joined
·
1,412 Posts
There is an update on the bolt they will replace both front bolts and the 2 bolts on the very front of skid. there is also an update on the smart valves and on the stearing block all is coverd by ac I had all updates done sat.
 

·
Registered
Joined
·
87 Posts
I can't find the part number you refrence. Could you please tell me what heading it falls under on the microfisch exploded assembly drawings.
Thanks for you help.
 

·
Registered
Joined
·
3,411 Posts
Mainecat,

Ws the spacer missing from that mounting point only? Did you check the other side and the 2 lower mounts of the front arm for missing spacers...??
-John
 

·
Premium Member
Joined
·
9,228 Posts
Discussion Starter #6
Jleo the others are there. Just the right front is missing. I couldnt believe it was not there.
 

·
Premium Member
Joined
·
9,228 Posts
Discussion Starter #8
jleo no you do not need to remove skid. If you have a loose bolt that you tighten and retighten chances are you have a missing spacer. My bolt came right out easy as it was missing the spacer.
 
1 - 8 of 8 Posts
Top