Hardcore Sledder banner

1 - 5 of 5 Posts

·
Registered
Joined
·
269 Posts
Discussion Starter #1
I'm want to cover the workbench in my garage with 16 ga Steel sheet. I want to have the metal wrap over the ends and the front edges. I need to find a shop who can shear and brake the sheet stock so it will fit nicely and cover the top of the bench. Do any of you guys know of a metal fab shop who could do this for a reasonable cost.
 

·
Registered
Joined
·
452 Posts
Par Metal on Jarvis did my bench. Bought a 120'' by 60" sheet from them and they sheared in half so it was 120" by 30''. Then they bent a 5 1/2" backsplash then 22" of surface then 2 1/2" drop. If they did that I am sure they can do what you need. Their number is 586-8121. The price was very reasonable too. Hope that helps

 
1 - 5 of 5 Posts
Top