Hardcore Sledder banner

1 - 1 of 1 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
We just returned from Wyoming and a problem we had is that the pipe is too close to the headlights. It melted a hole in the bottom of the left headlight assembly and warped the right one. A big portion of hood foam burned off the right side of the sled also.

It would not run when we arrived, Fuel pump was humming and could get no RPMs. We had to remove the little white rubber gasket in the Smart valve to get it going. Then worked real well.
 
1 - 1 of 1 Posts
Top