Hardcore Sledder banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,512 Posts
Discussion Starter · #1 ·
I am rebuilding a set of fox M-10 factory Polaris shock for my friend and I have the shocks apart but I need the gas pressure for the shocks, from the pressure that was in them it apprears to be 200 on the front shock and 250'ish on the rear does anybody know the correct numbers. I wrecked the top cap for the front shock and had to order a new one yesterday. Does anybody have any ideas for a better wrench for shock caps I use my Snap-On 1" but it is not as long as the flats.
 

·
Registered
Joined
·
2,156 Posts
tap around the shock body with a hammer before trying to loosen a stuck one and you should be able to get the cap off without destroying it. 300 PSI on the rear.
 
1 - 3 of 3 Posts
Top