Hardcore Sledder banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,498 Posts
Are you putting a new wear ring on the axle too ? These become grooved and even a new seal will leak. Also they get sharp edges on them that may be cutting your seal. Are you greasing the hell out of the new seal before slideing the axel in? If you dont pack the cavity between the seal and the bearing with grease,you will smoke the seal and groove out the wear ring in short order.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top