Hardcore Sledder banner
1 - 8 of 8 Posts

·
Registered
Joined
·
223 Posts
take a knife and cut out the middle part you'll see there's a gap then pus the hooks into that opening and tighten it down with i believe a hex driver. it's pretty easy just try to not to cut up your handlebars ends it will just look bad.
 

·
Registered
Joined
·
2,114 Posts
You need to back off on the allen bolt before you put it in the bar, then tighten it up, it should go right in, if not persuade it a little!!! Mine went right in on my 06 mxz, no problems???
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top