[REDWEDGE600]

I have a HOTSEAT 36s 48/36 angle, any way it is a all aluminum helix. I have been running it since 98.

What is happening is that on the back side where the snap ring/washer goes it is wearing a groove into the helix, and unfortantly it is not even. What would be a good replacement helix (OEM maybe)so I dont have this issue again?

As some of yoknow it is 98 XC 600 basically stock except for clutching, I am also running a Goodwin Perfromance/Polaris roller secondary, so that will effect helix choice some,

Thanks

 

[RogerBzXCR]

Dalton helix!! is by far IMPO the best designed and built helix in the industry

http://www.daltonindustries.com/snowmobile/welcome.htm

to see if they have the helix you need and you can order from a few different
places, I just found out about a distributor in Maine that works great for me

Automatic Distributors

Bangor, ME


(207) 942-6769

 

[polaris9500]

ot u could take a stock helix and have it recut to the angles u want. one with a cast hub.