[CCC Sniper]

I know i can plug it anywhere theres 12 volts but i thought maybe some of you pros would know exactly where its best to have a plug in for heated visor?

and any thoughts or ideas on this would be appreciated

http://www.royaldistributing.com/servlet/M...l&page=225.html

or would a single piple be better?

thx

 

[sledhead88]

I'm waiting on the same answer here bro. Hope to hear soon.

 

[byoffcr]

If pipe is only giving u 5-6 hp there is no way the cannister is giving u 5hp more like zip would be more accurate

 

[byoffcr]

Also if pipe & can. is 15 lbs weight savings how can there can be 17 lbs lighter

 

[captainkirk]

Hey Boys

There is a open plug behind the Power Valve servo motor...It has a 12V source.

Take off the servo from its bracket (2 bolts)...You should then see a double style open plug...With a test light the female end should be 12V...find a pin end for your "+" cord and then ground the other wire to a nut...The other male plug end on the sled could be a ground but did not check...

Hope this helps.

Captainkirk

 

[CCC Sniper]

thx dude, ill update yea on how it goes!!

 

[looneytune]

Yellow is always hot and the browns are ground wires. There is an accessory plug behind the servo bracket that I plugged into.

 

[VFRcanada]

I installed my plug in the dash where the ethanol switch was.

 

[VFRcanada]

pic from the back.

 

[Shameful1]

There is also a plug behind the speedo.

Detailed instructions can be found in an old post on this site.

 

[CCC Sniper]

Thanks, i did a search on it and found some good info