Hardcore Sledder banner
1 - 3 of 3 Posts

·
Registered
Joined
·
75 Posts
Discussion Starter · #1 ·
I am sure this is a common problem on many model sleds, but both sides of my handwarmers where they plug into the main wiring harness, the smaller wires became brittle and broke right at the plug. Can you buy just a new pigtail or do you have to buy the whole new handwarmer assembly? If you have to get the whole assembly, does anyone have any other fixes short of cutting the whole plug out of it and hardwiring it? I would rather not go that route........Anyone seen this before, what was your fix???
 

·
Registered
Joined
·
12 Posts
depending on the plug, you can pop out the little piece of metal inside it that acctualy makes the contact, solder it and slide it back in
 

·
Registered
Joined
·
411 Posts
Sorta of related - Say I Take off the stock bars for ones that have hooks and are fatbar and also have a pad, what do people normally do to the switches as now the insides are some what exposed to the elements.
 
1 - 3 of 3 Posts
Top