Hardcore Sledder banner
1 - 9 of 9 Posts

· Registered
Joined
·
46 Posts
Discussion Starter · #1 ·
I've got a 04 prox 600, I want to rise handle bars up another 2 inches from stock ones so does that mean I need to order 6 inch risers? I was also wondering are the stock cables and wires long enough so I don't have to replace them? thanks :beerchug:
 

· Premium Member
Joined
·
3,011 Posts
Do a search and there should be some topics about this. I know you can add 2" and use the stock cables. Can't remember if the stock riser is 3 or 4". But if it's 4" then yes you will need a 6" riser.
 

· Registered
Joined
·
667 Posts
[attachment=96688:attachment]

[attachment=96689:attachment]

[attachment=96691:attachment]


here is my 02 with a 6 inch, only thing that I dont like is that the wires are visible...they do not pull, there is enough room, but they are visible, everything else is good, and the bar pads are only like 20 bux, just grab a moto X pad I just got it all done with the new hand guards too, i still need to play around with the wires from the warmers and such, brake and throttle are no problem
 

Attachments

· Registered
Joined
·
653 Posts
henn1357 ...could you not use the pad that you got with the sled? that nice red one that mark had on it. i have the same one and i think it would fit.
 

· Registered
Joined
·
667 Posts
It does fit, you just have to run the brake line on the outside of the zipper, also with the riser it leares a space from the tank to the bottom of the pad cover..once I clean up the electrical lines it should look cleaner, it looks better then the pic show...
 

· Registered
Joined
·
197 Posts
i was going to ask the same quesion on here, i also have a polaris pro x with 4.5" risers. i am looking to buy 6" risers, and was wondering too if they fit. so i see they will and thanks for the responses. if anybodys looking to sell a set, im interested for the moment.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top