Hardcore Sledder banner
1 - 4 of 4 Posts

·
Registered
Joined
·
701 Posts
Discussion Starter · #1 ·
I would like to make sure my top and bottom gears are aligned correctly after replacing the 4 bearings in my 2003 F7. I tried using a straight edge along the outside of the case but I thought that the case may not be the best 'reference' plane. Is there a good method to do this that I'm not thinking of?
 

·
Premium Member
Joined
·
15,688 Posts
Take the chain off and run a straight edge along the 2 gear faces.
 
1 - 4 of 4 Posts
Top