Hardcore Sledder banner

1 - 5 of 5 Posts

·
Registered
Joined
·
328 Posts
Discussion Starter #1
I just replaced the gas tank in a 700 do I need to do anything to prime the system again or just fill the tank up and pull until it fires?
 

·
Registered
Joined
·
40,004 Posts
Just seal the filler neck best as possible while blowing some low pressure air in the tank for a few seconds. Make sure the fuel valve is on while doing so.
 

·
Registered
Joined
·
328 Posts
Discussion Starter #5
Just seal the filler neck best as possible while blowing some low pressure air in the tank for a few seconds. Make sure the fuel valve is on while doing so.
For fuel injection? I’ve done that with carbs but not a fuel injection
 
1 - 5 of 5 Posts
Top