Hardcore Sledder banner
1 - 7 of 7 Posts
G

·
Discussion Starter · #1 ·
i was out for a blast on the sled the toher day it a 03 firecat700 snopro.....it shut down on me then i got it started again i drove so far and flames and sparks started coming out of it,then i lifted the hood up and seen the metal wall(casing) around the engin seemed to be cracked right by the clutch where the shaft goes in and it was all worin away and snaped... i was wondering if any one had the same problem??
 

·
Registered
Joined
·
872 Posts
mine did the same thing. Good news is parts should only be ~$40. assuming you only need the brace (broken metal piece) and the bearing. Bad news that bearing was a bitch to get on and off. There has to be a better way then what I did. Heat, oil and a dremel (sp?) got it off. Heat, oil, some pounding and some help from a friend got it back on but wasnt fun. Good luck
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top