Hardcore Sledder banner
1 - 2 of 2 Posts

·
Registered
Joined
·
544 Posts
Discussion Starter · #1 ·
I was checking the jets to see if they were the right size. While I had the carbs off I was looking at the lines... the small coolant line on the pto side going to the pto side cylinder was rubbing on the bulk head.. it was a little worn.... so I checked the line going under the engine .... sure enough I felt an area where it was worn also.... it is Number 11 that is going under the engine... I couldn't find the part # for the coolant line going to the cylinder.
just a precaution......
 

Attachments

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top