Hardcore Sledder banner
1 - 4 of 4 Posts

·
Registered
Joined
·
574 Posts
Discussion Starter · #1 ·
I know this has been covered but I can't find. Can someone tell me what the wiring procedure is?

Haven't run out yet, but thought this would be good to know. ^_^

Thanks!
Actic2
 

·
Registered
Joined
·
574 Posts
Discussion Starter · #3 ·
Krom,

Thank you for the input, however I am a little confused. The reason I am asking for this information is that I have read here that if you run an EFI out of gas it takes many, many pulls re-pressurize and start sled (100-200 pulls?).

I am riding backcountry next week and although the fuel range/mileage of the F7 is more than adequate for this...well let's just say I've been there before! The sled is a late build and did not call for smart valve update. I have read here that you can cross wires to trick the EFI to rich mode, which is what you are describing, yet you say this only saves 3 - 4 pulls?
 

·
Registered
Joined
·
574 Posts
Discussion Starter · #7 ·
OK Krom, make sense now. These earlier out of gas posts were before the update. Again, my sled did not recieve this update, wasn't in the vin range. I Think I'll carry a couple of wires just to be safe.

Thanks again!
 
1 - 4 of 4 Posts
Top