Hardcore Sledder banner
1 - 2 of 2 Posts

· Registered
2,215 Posts
It's pressed so you either need a special puller or you can try what I just did last weekend on my sled. I put the shaft in a vise and busted the bearing up with a hammer until only the inner race was left. Then I heated the race with a propane torch and took a hammer and pounded it off with somthing pretty solid (I used a pipe). It will come off with a little persistence.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.