Hardcore Sledder banner

1 - 3 of 3 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter · #1 ·
So I'm helping my buddy switch over his suspension on his 1995 XCR 600 from the stock suspension to a 136 inch Xtra-10. He decided to replace the drive sprockets. So after much persuasion, he was able to get the old plastic sprockets off the bar but now we are struggling with how to get the new sprockets on, and how to ensure that they will be put on at the proper distance.

Can any one provide some advice on what the best way to install these new sprockets on the existing bar, that would be great!

Thanks!!
 

·
Registered
Joined
·
120 Posts
Discussion Starter · #3 ·
Thanks..we figured we needed to get someone to press them on there but weren't sure if we were just being a bunch of idiots and not doing something properly.

Thanks again!
 
1 - 3 of 3 Posts
Top