Hardcore Sledder banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2,423 Posts
Discussion Starter #1
I ordered a clutch kit from them a month ago and I ran it and it was way slower than stock and it turned out that they sent me the wrong helix. So they sent me a new one and I ran it this weekend and it is much better. I raced my friends f7 which is the same exact sled studs and all and out of the hole I would put 4 to 5 sled lenghts on him easially. But when we raced from a 30 roll he would pull on me just a little bit. I think it might of been because my rpms were a bit to low only 7400-7500 I think I will bump the spring up one notch and try it again.

I also raced my buddies 02 zr 800 with twin PSI pipes, reeds, clutch kit, power breather and 240 studs. we plowed a track on the lake and when we raced we were almost dead even every time. :D It all depended on who got the holeshot. My f7 had 170 studs and a DP clutch kit only. I think if I put in v-force reeds I will be able to beat him. I think the clutch kit helped from a dead stop but not from a 30 roll.
 
1 - 1 of 1 Posts
Top