Hardcore Sledder banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I went to install the D&D torque arm on my 2007 F8 Sno Pro and the holes would not align... i insalled the bracket that attaches to through the sled to the A-Arm okay, and then installed the bolt through the mount on the engine but then i cannot install the actual torque arm, the engine has to move up or back.

My sled is currently sitting on dollies, one under each ski and one under the track, could that cause the misalignment? How am I supposed to fix the alignment issue to install the torque bar??

Any Help would be much appreciated!
 

·
Super Moderator
Joined
·
12,779 Posts
Did you lengthen or shorten as required?
I would suggest final adjustment should be done with the sled slitting flat on the ground without front or rear elevated.
 

·
Registered
Joined
·
197 Posts
I went to install the D&D torque arm on my 2007 F8 Sno Pro and the holes would not align... i insalled the bracket that attaches to through the sled to the A-Arm okay, and then installed the bolt through the mount on the engine but then i cannot install the actual torque arm, the engine has to move up or back.

My sled is currently sitting on dollies, one under each ski and one under the track, could that cause the misalignment? How am I supposed to fix the alignment issue to install the torque bar??

Any Help would be much appreciated!
Were you able to just recently purchase this? Sorry looking for one and having trouble finding one. Thanks
 
1 - 5 of 5 Posts
Top