Hardcore Sledder banner

1 - 1 of 1 Posts

·
Registered
Joined
·
154 Posts
Discussion Starter #1
I was just taking the shock out for service and noticed that there are two sets of holes where the control rods bolt to the rear arm.Right now the rods run parallel with the shock.Does anyone know if the snopro is set up the same.I think if you moved the rods to give them some angle it would change the rate the shock moves .I am getting new springs because the stock ones have sagged out in 1000 miles,I hope that gives me back the ride I had when it was new.
 
1 - 1 of 1 Posts
Top