[ACman]

I am going to replace my weight bushings on my 99 ZL600 (17900 miles). Can anyone tell me what the torque spec is on the cam arm lock nut ? I know I need to buy a service manual.

Second question, my driven clutch seems to have a little play in it. It moves parallel with the shaft a good 1/32" (inch) and it seems to have a little play when it starts to rotate (it rotates slightly before the shaft rotates. Anyone else have this happen ? We checked my brothers 2000 ZR500 and his driven clutch doesn't have any play in it.

Thanks.

 

[ACman]

Correction 1,700 miles.

 

[expert]

Hi ACman, The cam arm bolt according to the ser. man is tighten nut until it bottoms of bolt shoulder and then 1/8 of a turn. As far as the movement on the clutch, that is normal for it "float" and it should move a small amount....can't remember what the exact measurement is, but that seems about right. If his clutch doesn't move...it should and then lube it with some anti seize.