Hardcore Sledder banner

Clutch offset

782 Views 1 Reply 2 Participants Last post by  Jeff - Rev'n7
I was checking the offsett and center to center on my sled this weekend. My offset was wrong. I was wondering how to go about adjusting it? Do you just put shims behind the clutch? It seems weird with the bushing holding everthing tight.
1 - 2 of 2 Posts
To adjust off-set, add or remove the washer shims on the shaft behind the secondary clutch. Rule of thumb is under .060 clearance on primary clutch. I set mine at around .020 - .030.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.