Hardcore Sledder banner
1 - 1 of 1 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter · #1 ·
Hi to every one i'm try to check clutch alignment on zr900 05 and the motor is way of if i want to put it in line with the tool there is not enough play on the motor mounts to adjust i would need to make hole in Bracket, Mounting bigger i even try to push with the rubber Bumper, Torque - Engine still not enough so any as trick i should know thanks to any one that replies
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top