Hardcore Sledder banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3,678 Posts
Discussion Starter #1
before the last couple of rides of the season, i noticed that i was a tad bit low on the chaincase fluid, i had to add about quarter to half a cup, didn't seem like much, and i noticed no leaks. Well, i'm in the process of putting this thing away for the summer, and now i noticed a little wetness behind the chaincase and on the shaft, so i'm off to the dealer, i know there were some previous posts about some possible bad bearings or bad seals?? Not sure what it said anymore, were there any problems with the factory warranting the repairs, and were the new parts of a revised state, or same as stock, thanks, just trying to get geared up for when i talk to the dealer,


thanks again
 

·
Registered
Joined
·
52 Posts
looked up a lower bearing for the FCat chain case, previous part #0702-485 has been replaced by #1602-051. There is also an O-ring in there #1602-801. Hope this helps
 
1 - 5 of 5 Posts
Top