Hardcore Sledder banner
1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Just bought me a Billet Head Kit from BMP, to my 2008 F6!

Do any of you guys know if I need to replace the original O-rings on top of the cylinder with new ones, when I'm installing the new Billet head?!

heemm... Anyone knowing the complete procedure for replacing the original cylinder-head with a new billet Head (momentum and so on...)?! - Have never done this before, and there was no instructions with the kit.
 

·
Registered
Joined
·
10,580 Posts
Its a pretty simple install for the billet head. Just drain coolant, take off the stock head, check the o-rings, if they look good you can reuse them but new ones never hurt anyone. Bolt the billet head up and torque down in an alternating pattern to 22-25lb-ft.

Chris.
 
1 - 3 of 3 Posts
Top