Hardcore Sledder banner
1 - 4 of 4 Posts

·
Registered
Joined
·
786 Posts
Discussion Starter · #1 ·
O.K. guys, I bought a used 98 xc7 parts sled and i am going to use the bottom in my 98 6. My question is if i remove the crank out of the 7 case can i install it in the 6 case? Why you ask? A crank bearing went, so i splitt my 6 case and been cleaning up the castings (blueprinting) and im hoping the 6 case will be less distorted if any. Also im replacing the seals and want to make sure the crank bearings are clean and well lubed for start up. I know i should send out the crank and have it rebuilt and matched to the case but snow is right around the corner :linemup: What do you think? Sorry about the long post, but we know how important our sleds are. Thanks, all the best, Sideways
 

·
Registered
Joined
·
786 Posts
Discussion Starter · #3 ·
The bottom ends are the same on those two motors.[/b]
Yup, just wondering if their is any reason not to swich homes for the crank, probably overthinking, GET ER DONE! :frech32:
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top