Hardcore Sledder banner

1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
If I wanted to see if the valves (APV) are working what RPM does the motor need to be at for them to move?F7.
 

·
Registered
Joined
·
267 Posts
7100 on acceleration, and 6900 comming down. Measure cable length, they are way to short, set up for free cable length of 36.5 mm.
 

·
Registered
Joined
·
137 Posts
I'm adjusting my APV cables as we speak.
In adjusting the cable to 36.5mm. do I pull the cable to its
end? or do I adjust it without any pull?
 

·
Registered
Joined
·
267 Posts
Snoace, pull any slack out of the cable without lifting the valve, and push the silver barrel into the cable at the same time. you will find that they will be all the way down, i mear the jam nuts will be bottomed, aif you make them as long as possible, they barely reach minumum spec.. gilly
 
1 - 6 of 6 Posts
Top