Hardcore Sledder banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3,676 Posts
Discussion Starter #1
i saw somewhere in the site that the servo will move at startup so that the valves will clean, i took the cover off the servo today for the hell of it to watch and see, but the wheel that the cables were in on the servo didn't move at all on start-up, i haven't put it in a stand to check higher rpm's and see if it moves, but is there any others that can back up the fact that it is supposed to have a cleaning cycle or something on startup??

thanks
 

·
Registered
Joined
·
1,094 Posts
i have a 500 zl and the servo does move the cables while at idle and when you rev it up i saw it do this a number of times i also removed the cables from the servo and yanked on them and let them snap back so far so good 657 miles and no sticking
 
1 - 2 of 2 Posts
Top