This is the setup I am using....
Using the existing cable and the existing hole in the right side of the
hood.Disconnect wire at top of air box and install on outside hood bolt.Take
of nut on hood and clip and place in hole where zip tie was.Repeat the same
process for the left side.
The only thing I noticed is that the might wind out the holes in the front
of the hood,if you have hood screens no big deal.Also,the wires could have
gone up another inch or so more on the hood.The hood just opens a little
further.
Oh well...at least there wont be any holes in the air box !
Using the existing cable and the existing hole in the right side of the
hood.Disconnect wire at top of air box and install on outside hood bolt.Take
of nut on hood and clip and place in hole where zip tie was.Repeat the same
process for the left side.
The only thing I noticed is that the might wind out the holes in the front
of the hood,if you have hood screens no big deal.Also,the wires could have
gone up another inch or so more on the hood.The hood just opens a little
further.
Oh well...at least there wont be any holes in the air box !
Attachments
-
11.8 KB Views: 73