Hardcore Sledder banner

Adjusting track on F5/F7

4228 Views 22 Replies 10 Participants Last post by  jleosnow
I don't want to sound stupid :huh: , but I am going to ask anyways. They say the only "stupid" question is the un-asked question.... :p

When adjusting the track tension, after loosening the large 1 ½ axle nut…. do the small nyloc nuts need to be held with an open-end wrench while turning the adjusting bolts? What about when you are all done adjusting and you tighten the rear axle nut to 30 ft. lb., do you need to snug up the nyloc nuts on the adjusting bolts? Very different than the previous sleds (ZR/ZL’s)
Thanks!
-John
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top