Hardcore Sledder banner

Accessory connection

724 Views 1 Reply 2 Participants Last post by  firecat_freak
I connected my shield to the accessory connecton by the servo motor but the voltage was only 11 volts dc.
My 2002 ZR carb the voltage was 15 v ac and went higher when you reved it.

Is this normal, will my shield work ok?
1 - 2 of 2 Posts

· Registered
Joined
·
3,865 Posts
these are twelve volt systems, 15 would have been too hight, your voltage regulator was not doing too good it sounds, next thing you lights would have been blowing up, eleven volts will do just fine
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top