Hardcore Sledder banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
113 Posts
What is the drill bit size for 96 xlt special to sychornize the carb and set idle?[/b]
Just use a small one. This is only going to get you in the ball park. Adjust the idle screw until the bit just barely fits under each slide so that the slides are all set at the same height. Once that is done hook the throttle cables to the carbs and make sure that as you squeeze the throttle they all raise at the same time. If they don't, adjust the cables till each one raises at the same time.

Once you put the carbs back on you will still have to adjust the idle. The only thing the drill bit did was make the idle on all three the same. If you have to raise or lower the idle make sure you do all three exactly the same (half turn at a time)

Hope this helps.

Mike
 
1 - 4 of 4 Posts
Top