Hardcore Sledder banner
1 - 1 of 1 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter · #1 ·
What is the recommended jet size for 10/-10 f @ 0-1000ft, and needle setting. It is running 360 jets and the needles are set to the lowest position. This motor let go this past winter due to running lean, and it is currently new from top to botton @ .025" over. Any recomendations would be appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top